Skip to end of metadata
Go to start of metadata

Available since 3.8.1

 

Sometimes there is a need to force the user to set some additional attributes to his profile. Usually all information are based on the records from HR system or set directly into midPoint by hand of administrator. However, not all information could be present in HR or even administrator doesn't know them. In such cases the post-authentication is the best approach how to collect such data. To enable post-authentication in midPoint it is needed to configure the flow policies. This configuration is described bellow.

Configure post-authentication flow

Since midPoint 3.7 there has been added support for self registration and self post-registration. The self post-registration is very similar to the post-authentication flow. The configuration of both are made in security policy. To enable post-authentication you will need to add the following snippet to the system configuration. 

Post-authentication configuration

The example bellow specifies when to enforce the post-authentication for user. The important setting is in requiredLifecycleState. It tells which users are forced to perform post-authentication. Using the example above, the users with the lifecycle state set to the proposed are automatically redirected to the post authentication form after the successful login. As the post-authentication form custom defined form which is shown to the user can be specified  using formRef as in the example above. If the formRef is not specified, the form is the same as on the user details - basic tab. 

Configure lifecycle activation

To successfully authenticate to midPoint user has to provide correct credentials and has to be enabled. The enable/disable status of the user is computed based on different properties, e.g attributes validTo, validFrom, administrativeStatus. However the lifecycle state also plays its role in the computation. If the user has lifecycle state e.g. proposed (and the administrative status is not set to enabled) by default it means that this user is disabled and should not login to the midPoint and perform any actions. But, with this premise it is not possible to enforce post-authentication for such a user because he is not even able to login to midPoint. Therefore there is a need to configure the lifecycle activation. Basically, according to the configuration as shown bellow we can enforce other lifecycle state of the user. 

Lifecycle activation configuration

The configuration above shows the configuration for lifecycle state. In the part lifecycleStateModel there are two section, fist for the proposed doesn't have any forcedActivationStatus. It means that if the user has lifecycle state set to the proposed, midPoint thinks that there is no lifecycle state (no forcedActivationState means no lifecycle state). In the second section, if the user's lifecycle state is set to draft, the user is considered to be archived and therefore midPoint evaluates it as disabled. Basically, to activate and enforce the post-authentication for the users the value of requiredLifecycleState must not have any forcedActivationStatus or the forcedActivationStatus has to be set to active. Only then the user can login to the midPoint and then perform the post-authentication.

  • No labels